Radiator Server Documentation — v10.34.2
Table of Contents

ip

This specifies the ip address(es) on which the server will listen for incoming connections. The ip attribute can be defined as an IPv4 or an IPv6 address and does not need an additional prefix to determine the type.

Recommended listen configuration:

listen {
    protocol udp;
    port 1812;

    # Bind to all IPv4 addresses
    ip 0.0.0.0;

    # Bind to all IPv6 addresses
    ip ::;
}

All ip addresses in a listen block share the port set with port. A listen block with ip requires port, unless an addr statement supplies the port.

When the IP attribute is defined as 0.0.0.0 (for IPv4) or :: (for IPv6), the server will listen on all available network interfaces for that particular protocol. The server binds each address separately. Do not combine 0.0.0.0 with other IPv4 addresses, or :: with other IPv6 addresses, on the same port. The operating system rejects such overlapping bindings.

Multiple specific IP addresses can also be configured:

listen {
    ...

    ip 127.0.0.1;
    ip 192.0.2.42;
    ip 2001:db8::42;
    ip 2001:db8::43;
}